image
image

  image
 

(480) 892-6969

Handleset & Bore Information

 

Backset Plates

Square Corner Radius Corner


Strike Plates

Square or Radius

 

NOTE: The drawing and information is what is commonly used. If your door prep is different then this, an illustrative drawing will be needed.

 

A. BACKSET DIMENSION- Measure from the edge of the door to the center of the hole. ( Standard is 2-3/8" or 2-3/4")

B. HOLE SIZE- Measure the hole from edge to edge. (Standard is 2-1/8")

C. BORE DISTANCE- Measure the distance between the two edge bores from center to center. (Standard is 5 1/2" or 6")

D. HANDLE LENGTH- Measure from the center of acturers are the bore to the center of the screw hole (There is no standard, all manufacturers are different.) Does the screw go through the door?

E. DOOR WIDTH- (Standard exterior door is 1-3/4" & a standard interior door is 1-3/8") If your door is thicker please state.